Digital Equipment Corporation RAID Array 3000 storage subsystem Installation Guide download pdf (Page 18)

Chapter 1. Expansion Pedestal Option

EK–SM3KA–IG. A01 1–9

11. Remove the “knock-out” plate located above the D1 OUT label on the rear

panel of the base pedestal (see Figure 1-9).

Figure 1–9 Remove Connector Knockout Plate

3000-45

Remove Knockout

from D1 Out

12. Connect cable assembly 17-04454-01 between the D1 OUT bulkhead open-

ing and the device # 1 backplane connector (see Figure 1-10). Secure the

bulkhead connector by tightening the two 6-32 SEM screws.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24 25

No comments

Digital Equipment Corporation RAID Array 3000 storage subsystem Installation Guide Page 18