Digital Equipment Corporation RAID Array 3000 storage subsystem Installation Guide download pdf (Page 14)

RAID Array 3000 Pedestal Enclosure

1–4 EK–SM3KC–IG. A01

8. Remove the existing controller (Figure 1-4) and install the third module into

the empty SIMM connector using the same procedure described in steps 6

and 7.

Figure 1–4 Remove Controller from Top Slot

9. Replace the existing controller into the top controller slot in the pedestal and

seat it into place by pushing forward on the side quick-disconnect handles.

Make sure the guides on each side of the controller align with the guides in

the slot.

10. Remove the dummy filler panel from the bottom controller slot by pulling

the handle straight out.

11. Install the second controller into the bottom controller slot and seat it into

place by pushing forward on the side quick-disconnect handles.

12. Power up the subsystem and refer to the

RAID Array 3000 Configuration

and Maintenance Guide

for information describing how to configure the re-

dundant controller option.

1 2 ... 9 10 11 12 13 14 15 16

No comments

Digital Equipment Corporation RAID Array 3000 storage subsystem Installation Guide Page 14